While it the plywood doesn’t need to be exactly the size of the frame (because of how we planned on trimming it later) we needed to make sure the plywood didn’t stick up any higher than the 2x4 seat because we needed a nice flush top for the next step in the build… We sandwiched the 2x4s, securing the plywood with finish nails. This was to give us full access from the external hatch since the bottom of the door already lines up with the floor of the camper and we didn’t need to make the access area any shorter.Īfter the main base frame was built, we began closing in the sides using 1/4” plywood. You may have noticed instead of running a bottom footer board along 100% of the base, we left a small gap in the center frame on the wall side. We secured the 2x4s to each other and to the floor. Knowing we wanted to use one of our wings for fresh water tank storage (the one on the right), we started by building the wings as full, uninterrupted cabinets and then filling in the space between with the centered bench.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |